question

Talia Z avatar image
0 Likes"
Talia Z asked Joshua S answered

Add logic to transporter flow between queue and separator

I want to add logic to the separator where I check to see if the truck on the "Unload truck" separator is empty and, if it is empty, Transporter1 should transport all of the empty pallets from "Broken down dunnage" into the empty truck - the truck will then drive away. I am having trouble adding this logic without losing the current Transporter1 movements. Thank you in advance for any guidance you may share!

bottle-unloader-process-v2.fsm

FlexSim 17.2.5
queuetransporterlogic
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Joshua S avatar image
0 Likes"
Joshua S answered

See this post for the answer.

Post

5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Isaac Litster avatar image
0 Likes"
Isaac Litster answered Talia Z commented

Hi @Talia Z

Transporter1 seems to lose its movements because there is not enough capacity in the Caps Queue. I found that increasing the Maximum Content in the Caps Queue allows Transporter1 to continue its operations. Hopefully this helps.

· 3
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Talia Z avatar image Talia Z commented ·

Hi Isaac! Thank you for the advice. Can you help me figure out how to add the logic I mentioned in the question?

0 Likes 0 ·
Joshua S avatar image Joshua S Talia Z commented ·
@Talia Z

I'm guessing the question you posted after this one is the route you decided to go with this logic?

0 Likes 0 ·
Talia Z avatar image Talia Z Joshua S commented ·

Yes - I appreciate your help! @Joshua S

0 Likes 0 ·