question

Gary Q avatar image
0 Likes"
Gary Q asked Gary Q commented

process flow configuration

How can I emulate the model shown in process flow? The problem I have is to imitate the maximum value of the queue, which if it exceeds 5 goes to the sink

I leave the model for a better understanding
modelo.fsm

FlexSim 19.0.0
process flow
modelo.fsm (22.1 KiB)
· 2
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Sam Stubbs avatar image Sam Stubbs ♦ commented ·

For clarification, what is your purpose in simulating a queue max size without using the queue's built in max size setting?

0 Likes 0 ·
Gary Q avatar image Gary Q Sam Stubbs ♦ commented ·

@Sam Stubbs

it's simple academic curiosity I was doing some queuing theory exercises, checking the results proposed in books with the simulator I'd appreciate your help
0 Likes 0 ·

1 Answer

Allister Wilson avatar image
1 Like"
Allister Wilson answered Gary Q commented

Attached is an example of your model's behaviour in Process Flow using a Zone to represent the queue.
It's setup to generate a token when an item is created in the 3D model, so the Process Flow mirrors the 3D model state.

I'm not entirely sure if this is what you were after though.

24459-modelo-1.fsm


24459-modelo-1.fsm (25.2 KiB)
· 1
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Gary Q avatar image Gary Q commented ·
@Allister Wilson

Yes, it is what I was looking for. Thank you very much for the help

0 Likes 0 ·