Exception Caught in dispatchtasksequence

Question

question

Mia L asked Aug 10, '20 Jeff Nordgren answered Aug 11, '20

Exception Caught in dispatchtasksequence

I am using 3D model logic in my model, however it stops running at 60 seconds OnProcessFinish of my combiner, stating that there's an error in my task sequence. I cannot figure out what went wrong, may I have assistance?

Prototype Standard Logic.fsm

Software Version:

FlexSim 19.2.4

flexsim 19.2.4 exception logic onprocessfinish

prototype-standard-logic.fsm (39.8 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2020-08-11T16:22:45Z

Jeff Nordgren answered Aug 11, '20

@mia.l,

Attached is you model with the small change that I made. Instead of putting OnExit code in the End Setup Queue24 I put the code in the OnEntry trigger. Minor timing problem.

Does this model work now for you?

Thanks.

prototype-standard-logic-JN1.fsm

prototype-standard-logic-jn1.fsm (39.7 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

question