I would start by setting a label called "Type" based on a percentage. The bernoulli distribution is a good one to use when you only have a choice between two values based on a percentage. Then I would change the color based on the label. Here is a screen shot of how I did that:
Next you need to change the Send To Port requirement so that it uses the type label.
This should get you where you want to be. Good Luck!Brandon
13 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
Privacy | Do not sell or share my personal information | Cookie preferences | Report noncompliance | Terms of use | Legal | © Autodesk Inc. All rights reserved