Why does AGV not move after TimeTable on break?

Question

question

jaehwans asked Jun 11, '21 jaehwans commented Jun 14, '21

Why does AGV not move after TimeTable on break?

I have set up a TimeTable for the AGV to be on 'off shift' for some time.
After the TimeTable ends, I can't figure out why the AGV is not moving.
Any help is appreciated, Thank you.

(A side question for the processor. Why the processor not doing the processing animation with animate option checked?)

210611_AGV, Time Table Behavior Question_v21.1.2.fsm

Software Version:

FlexSim 21.1.2

agv processor flexsim 21.1.2 timetable

1623376919834.png (311.8 KiB)

1623376974529.png (82.9 KiB)

210611-agv-time-table-behavior-question-v2112.fsm (237.2 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2021-06-11T20:00:23Z

Eric M answered Jun 11, '21 jaehwans commented Jun 14, '21

Hi @jaehwan.s, it looks like the issues came from the exceptions you were getting. The time table is working as it should, but the error at the floor storage is what keeps the AGV from continuing to work. If you update the max content of the storage to be the number of slots (6 or 7) this exception goes away and the AGV works as expected.

The processors had a 'on pre-draw' trigger in their tree under variables that was causing the issue with the animation. When I deleted that node, the animation began to work.

210611-agv-time-table-behavior-question-v2112 (1).fsm

210611-agv-time-table-behavior-question-v2112-1.fsm (125.9 KiB)

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

jaehwans commented · Jun 14, 2021 at 12:26 AM

Thank you

0 ·

question