question

Ilaria B avatar image
0 Likes"
Ilaria B asked Ilaria B commented

exception: Exception caught in evaluation of /Tools/..

Hi,

I have this exception in my model. I found in the model other questions but i can't debug because the problem occures randomly. The model doesn't stop, by I don't understand if it is a serious problem in the logic or just in the graphical objects.

Can you please help me?

Your help would be very helpful for me.

The model is attached ml39.fsm

FlexSim 16.1.2
exception error
ml39.fsm (944.9 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

zacharyh avatar image
0 Likes"
zacharyh answered Ilaria B commented

I have run through your model for a full 24 hours (simulation time), do you know when the error might occur or is it completely random? If your model continues to run I believe it could just be a graphical error.

· 8
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Ilaria B avatar image Ilaria B commented ·

You're right, i forgot to upload the version with the parameter "Tempo Ciclo" setted to a number smaller than 5. With 5 there are no problems. cattura11.jpg

0 Likes 0 ·
cattura11.jpg (9.7 KiB)
Ilaria B avatar image Ilaria B commented ·

Can you please change the value and run the model? The error occurs randomly

0 Likes 0 ·
zacharyh avatar image zacharyh ♦ Ilaria B commented ·

Where exactly in the model did you change the cycle time?

0 Likes 0 ·
Ilaria B avatar image Ilaria B zacharyh ♦ commented ·

In the dashboard named "Operators". The editing button is linkend to a tree node called "TC".

0 Likes 0 ·
Show more comments
Ilaria B avatar image Ilaria B commented ·
@Zachary H

I tried to save the model but the situaution doesn't change. Here the exception:

cattura111.jpg

0 Likes 0 ·
cattura111.jpg (17.2 KiB)
zacharyh avatar image zacharyh ♦ Ilaria B commented ·

I was not able to recreate that error but found another error. When running the model if I click the process flow it would stop with an error. This was a bug fix in later FlexSim Versions. I would recommend upgrading versions if possible to FlexSim 19.0. If your model is still running after getting your error then you should be getting the desired outputs. One way that could help you debug your error is by changing the names in process flow. Such as instead of the 9 different instances that you have called "Load" in process flow, number them "Load1", "Load2", "Load3", etc.. This will better allow you to see exactly where the error pops up.

0 Likes 0 ·
Ilaria B avatar image Ilaria B zacharyh ♦ commented ·

Thanks, i will try and let you know.

0 Likes 0 ·