Process flow error

Question

question

Doris C asked Apr 11, '24 Felix Möhlmann answered Apr 11, '24

Process flow error

Hi.

As shown in the picture below, the control section was created using the process flow

The control contents of the photo are as follows

It is a process structure that repeats the work of WAIT FOR EVENT (source CP26) again after confirming that two AGVs have passed since arriving at WAIT FOR EVENT (source CP26) after confirming that two AGVs have passed since arriving at WAIT FOR EVENT (source CP26).

What is wrong with the ash setting that process doesn't work?

I would appreciate it if you could explain the revised file and the explanation of the mistake I made.

thank's you

PROSESSFLOW-ERROR.fsm

Software Version:

FlexSim 24.0.2

agv processs flow tokens

prosessflow-imege.png (33.7 KiB)

prosessflow-error.fsm (119.5 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2024-04-11T11:12:35Z

Felix Möhlmann answered Apr 11, '24

The issue is that redirecting an AGV so a CP (as final) while it is already at that CP does not finish its travel task. I'm not sure if that is a bug or intended.

But since CP26 and CP45 are travel directions in the subflows anyway, you could simplify the logic by just placing the Push to List activities into the subflow.

prosessflow-error_1.fsm

1712833943496.png (29.7 KiB)

prosessflow-error-1.fsm (113.6 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

question