question

Ryusuke T avatar image
0 Likes"
Ryusuke T asked Ryusuke T commented

How to detect when a point is reached in GIS

Hi,

I'm placing a point as a waypoint in GIS. Is there a way to detect when this waypoint has been reached?

As far as I can see from the spoiler, the only events for points seem to be On Message and On Simulation Start.

1726745840659.png


FlexSim 24.0.4
gis navigator
1726745840659.png (380.2 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Felix Möhlmann avatar image
0 Likes"
Felix Möhlmann answered Ryusuke T commented

I don't think this is possible. There is no event associated with passing points along a route. You might just have to split the travel task into multiple stages to know when the TE arrives at each stage's destination.

· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Ryusuke T avatar image Ryusuke T commented ·

@Felix Möhlmann ,

Thank you for your answer.

I wanted to treat this point as a service area and do a simulation where I would take a break at a service area when I had traveled a certain distance.

I would like to post this idea again.

0 Likes 0 ·