If you are asking what I think you are asking, all you need to do to is make a simple port connection from the conveyor to the processors. (Hold "A" key and click drag three times to each processor.) Then simply open up the conveyor's Exit Transfer object's properties, (the exit transfer is the little white square at the end of the conveyor) and choose a "Send To Port" function. (In my example I simply chose "Round Robin")
(See the example I attached below)
You would connect the conveyor to the three processors just like you would connect any other object to three processors. "A" key connect to the processors.
Is this what you were looking for?
5 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
Privacy | Do not sell or share my personal information | Cookie preferences | Report noncompliance | Terms of use | Legal | © Autodesk Inc. All rights reserved