AGV TaskExecuter & Process Flow

Question

question

michel.torbey asked May 4, '17 Matthew Gillespie edited May 22, '19

AGV TaskExecuter & Process Flow

Hello,

I've been trying to control a TaskExecuter (AGV) with process flow.

I assigned a resource to the TaskExecuter and when i acquire the resource and use a travel command, the TaskExecuter doesn't travel.

It only happens in the Updated flexsim version 17.1.2.

Any Clue what is happening?

Best regards,

Software Version:

FlexSim 17.1.2

process flow task executer

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2017-05-05T17:00:01Z

Sam Stubbs answered May 5, '17 michel.torbey commented May 8, '17

Yes, so by default TaskExecuters have no default navigator. If you want the AGV to operate outside of a network, then you'll need to have a default navigator. If you don't have any operators, drag out an operator from the library. They will create a default navigation when they first enter the model. You can then delete the operator afterwards.

Then just open the AGV's properties, and under the TaskExecuter tab at the bottom, select Default Navigator from the dropdown.

navigation.png (24.3 KiB)

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

michel.torbey commented · May 08, 2017 at 11:33 AM

@Sam Stubbs thank you it works fine!

0 ·

question