save message with Process Flow library

Question

question

Alessio Merlo asked May 7, '18 Jacob Gillespie edited Dec 14, '18

save message with Process Flow library

Hi,

after updating my library from FlexSim 17.0.13 to 18.0.5, I noted that FlexSim asks me every times that I create a new model to save the previous one even if I just start the software.

I believe that the issue due to the code "MAIN:/project/exec/globals/nodefunctions/shouldpromptforsavescripts/processFlow" which recognizes the process inside my library like a model process, then FlexSim asks me to save it.

Does someone experiment my same case?

To reproduce the issue, I tested this sequence:

- install testLib.fsl inside standard FlexSim folder (I attached the file testlib.fsl);

- start FlexSim 18.0.5;

- click on "New Model" option of the start page;

At this point message "Do you want to save the model?" appears.

Have you any solution for this problem?

I don't test, but I believe that the issue persists also in FlexSim 18.1.1.

Software Version:

FlexSim 18.0.5

process flow library flexsim 2018 save message

testlib.fsl (3.1 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2018-05-07T14:54:36Z

Phil BoBo answered May 7, '18 Jacob Gillespie edited Dec 14, '18

I'll add this issue to the dev list.

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jacob Gillespie ♦ commented · Dec 14, 2018 at 08:59 PM

This has been fixed. The fix will be in the FlexSim 18.0.9 update.

0 ·

question