question

Nisa O avatar image
0 Likes"
Nisa O asked Matthew Gillespie edited

The model only does not stop the flow if the robot is very slow?

What might be the reason that my model stops working after 1243 items leave the sink?

Then I reopened the model, it stopped after 1316 objects left.

Then I reopened it is 2000 this time. Then I reopened again it is 1243.

What is the reason for such an error? This is confusing.

When I made the robot who loads the items slower, it produced correctly. Why is this? (the robot should not be slower :()


Any help would be much appreciated.

FlexSim 18.2.2
Choose One
model stops running
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

tannerp avatar image
1 Like"
tannerp answered Nisa O commented

Hi @Nisa O,

The problem was that the Combiner1 had an output option set to send the items to a port depending on the length of subnodes of a conveyor. I'm not sure why that was set as such, but I've fixed it to send the items to the conveyor (Output port 1) and it runs to completion (time 216000.00) for me.

Please review this updated model and let us know if it works as desired. Thanks!

model-stop-problem.fsm


model-stop-problem.png (26.0 KiB)
model-stop-problem.fsm (1.5 MiB)
· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Nisa O avatar image Nisa O commented ·

This is funny. It worked! You are the best, you really saved me a couple of hours.

Thank you so much,

Best regards,

Nisa

1 Like 1 ·