question

Mingzhi C avatar image
0 Likes"
Mingzhi C asked Mingzhi C commented

AGV could not find a valid path during simulation

I set up an AGV and run a simulation.but at 4000 sec, an error occurs. The error is shown below:.
I don't know where was wrong. Does anyone know how to resolve this issue? Any assistance would be appreciated. The corresponding documents are attached.

Thank you!


agv-problem-sample.fsm

FlexSim 19.2.0
agv networkagv path
pic.jpg (21.9 KiB)
agv-problem-sample.fsm (381.3 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Steven Hamoen avatar image
1 Like"
Steven Hamoen answered Mingzhi C commented

@Mingzhi C If I open your model in 19.2.4 it runs fine, no errors. I ran it till 400000 seconds. So maybe update your FlexSim to 19.2.4

· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Mingzhi C avatar image Mingzhi C commented ·

Thank you ! Seem 19.1 ~19.2.0 still have the problem, but 19.2.3 is fine.

0 Likes 0 ·