As an extension of this exercise, I want to check if an AGV is loaded or unloaded when it arrives at a control point. I created two tracked variables, AGVLoaded and AGVEmpty which will be incremented depending on the AGV status at the control point where the check happens.
I think it should be possible using a simple conditional decide, but it seems like I keep referencing the AGV at the control point and not its subnodes.
What is wrong here?
You should use the source to assign the agv as a label:
and then use token.agv.subnodes.length
At the moment there is no arrival event - try using pre-arrival.
16 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
