question

Manuel F. Silva avatar image
0 Likes"
Manuel F. Silva asked Manuel F. Silva commented

Problem / doubt in FlexSim conveyors tutorial - Task 3.1 - Step 3

On "STEP 3 Add Gaps Between Items After the Merge" of the "Tutorial 1.3 - TASK 1.3 - ADDING AND REMOVING GAPS", after completing point 14, I start having errors in the model and I can not run it according to what was expected - can anyone explain what am I doing wrong? I have double checked that I am following all steps mentioned in the tutorial. I attach the model on which I was working so that you can take a look at it.

My model is attached: Tutorial_1_3_Adding_and_Removing_Gaps_Step_3.fsm

Thanks in advance.

FlexSim 21.0.2
flexsim 21.0.2
tutorial-1-3-adding-and-removing-gaps-step-3.fsm (49.3 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Marcello Rosadini avatar image
0 Likes"
Marcello Rosadini answered Manuel F. Silva commented

Hi Manuel,

there are no errors in your model. Most likely, some of the connections between conveyors were moved, attached you'll see your model. I've just moved a little bit the conveyors to reconnect them and replaced a new PE. As you get more familiar with the conveyor module, you'll find it easier to troubleshoot. slug support2.fsm


slug-support2.fsm (49.2 KiB)
· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Manuel F. Silva avatar image Manuel F. Silva commented ·

Hi Marcello,

I had installed FlexSim version 21.0.2 - after upgrading to version 21.0.4 all these problems disapeared and I was able to run this tutorial without any problem.

Thank you for all your assistance.

0 Likes 0 ·