Problem / doubt in FlexSim conveyors tutorial - Task 3.1 - Step 3

Question

question

Manuel F. Silva asked Apr 20, '21 Manuel F. Silva commented Apr 21, '21

Problem / doubt in FlexSim conveyors tutorial - Task 3.1 - Step 3

On "STEP 3 Add Gaps Between Items After the Merge" of the "Tutorial 1.3 - TASK 1.3 - ADDING AND REMOVING GAPS", after completing point 14, I start having errors in the model and I can not run it according to what was expected - can anyone explain what am I doing wrong? I have double checked that I am following all steps mentioned in the tutorial. I attach the model on which I was working so that you can take a look at it.

My model is attached: Tutorial_1_3_Adding_and_Removing_Gaps_Step_3.fsm

Thanks in advance.

Software Version:

FlexSim 21.0.2

flexsim 21.0.2

tutorial-1-3-adding-and-removing-gaps-step-3.fsm (49.3 KiB)

Answer 1 · 2021-04-20T10:25:01Z

Marcello Rosadini answered Apr 20, '21 Manuel F. Silva commented Apr 21, '21

Hi Manuel,

there are no errors in your model. Most likely, some of the connections between conveyors were moved, attached you'll see your model. I've just moved a little bit the conveyors to reconnect them and replaced a new PE. As you get more familiar with the conveyor module, you'll find it easier to troubleshoot. slug support2.fsm

slug-support2.fsm (49.2 KiB)

· 1

Manuel F. Silva commented · Apr 20, 2021 at 09:18 PM

Hi Marcello,

I had installed FlexSim version 21.0.2 - after upgrading to version 21.0.4 all these problems disapeared and I was able to run this tutorial without any problem.

Thank you for all your assistance.

0 ·

question