AGV Travel to specific path

Question

question

Jotam C asked Mar 23, '22 Jotam C commented Mar 30, '22

AGV Travel to specific path

I am trying to make each AGV go to a specific pickup and drop off location. Essentially, I have two AGVs, each one with specific pick up and drop off locations. They do share one pickup and drop off location though. I need the AGVs to stop ONLY at the locations provided in the picture below. They should take distinct paths. Any help would be appreciated! I have attached the flexsim model as well.

Unit Simulation Model.fsm

Software Version:

FlexSim 21.2.4

agv agv path

capture.png (8.2 KiB)

unit-simulation-model.fsm (68.9 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2022-03-24T00:04:31Z

Jason Lightfoot answered Mar 24, '22 Jotam C commented Mar 30, '22

This sounds like you should not be using an AGV process flow template - but simple transport tasks maybe with a dispatcher.

· 6

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Jotam C commented · Mar 25, 2022 at 01:56 PM

Thank you for your feedback! I just recreated the model using a dispatcher and it is working fine. However, how can I prevent collisions at shared pickup/drop off locations? I am aware of the traffic control object but I feel like that is used more at intersections. Any thoughts on this?

0 ·

Jotam C Jotam C commented · Mar 25, 2022 at 02:02 PM

They should not be able to pass over each other. How can I prevent this from happening?

0 ·

Ryan Clark Jotam C commented · Mar 25, 2022 at 11:05 PM

Hi @Jotam C,

Could you post your updated model? That will allow us to help you more effectively. Thanks!

0 ·

Jotam C Ryan Clark commented · Mar 28, 2022 at 12:27 PM

Here is the updated model! Unit Simulation Model - Dispatcher.fsm

0 ·

unit-simulation-model-dispatcher.fsm (87.4 KiB)

Show more comments

question