question

Tushar H avatar image
0 Likes"
Tushar H asked Tushar H commented

Operator Not working as per Sequence

Hello All,

In my model, I operator is not working as per sequence.

Sequence: Operator pick 1 part from rack 1 & rack 2 - assemble on station 1 -After processing- operator pick 1 part from rack 3 & rack 4 - assemble on station 2 - After processing - operator pick the assembly and place in rack 5.

I have also used priority but it's not working.

If possible please apply in my model.

Please find the attached model for your reference.Operator task sequence.fsm

Thank you in advance.


FlexSim 23.0.1
operator task
operator-task-sequence.fsm (49.8 KiB)
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

1 Answer

Joerg Vogel avatar image
0 Likes"
Joerg Vogel answered Tushar H commented

I set priorities in supporting jobs for any taskexecuter!

And it works!process-sequence-operator.gifprocess-sequence-operator.jpgoperator-task-sequence_JV.fsm


process-sequence-operator.gif (1.9 MiB)
process-sequence-operator.jpg (52.0 KiB)
operator-task-sequence-jv.fsm (52.0 KiB)
· 2
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Joerg Vogel avatar image Joerg Vogel commented ·
to prevent any runtime errors: I added a delay task of 0 seconds to the end of every tasksequence in the trigger On Receive Task Sequence of involved operator!
0 Likes 0 ·
Tushar H avatar image Tushar H Joerg Vogel commented ·

Thank You So Much

0 Likes 0 ·