Robot Pick and Place: Pick and Place on conveyor after the Processor work

Question

question

Lamm asked Feb 16, '24 Lamm commented Feb 16, '24

Robot Pick and Place: Pick and Place on conveyor after the Processor work

Hi Team,

I am a new FlexSim learner. I am learning about robot simulation with FlexSim at the moment.

I build the model with 2 conveyors, input and output. 1 Processor.

The robot I want to build can run in phases: Load item in - Stand by - Load Item out

The process is:

Phase 1: The conveyor loads the item in, and the robot picks up the item and puts it into the processor, the robot goes to the standby position.

Phase 2: when the processor finish, the robot starts from the standby position, loads the item out, and places it on the output conveyor and the item goes to sinks.

When I build the simulation, the Phase 1 is good. The issue occurred in Phase 2, the item now appears under the conveyor, and the robot is stuck in the processor. (Picture)

I am trying to use Robot Motion Paths to do all the work.

What should I do to correct the simulation run like the process I want? Thank you.

Here is my model: robot simple simulation_ver2.fsm

P.S. 1: It seems like when I put the station mark on the conveyor, it makes the item not move, the item is placed under the conveyor. What should I do if I like to place the item in another position on the output conveyor?

Software Version:

FlexSim 23.2.1

robot

1708068014072.png (500.6 KiB)

robot-simple-simulation-ver2.fsm (820.3 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2024-02-16T08:07:03Z

Felix Möhlmann answered Feb 16, '24 Lamm commented Feb 16, '24

Items need to enter a conveyor through an Entry Transfer (the little while square that the source connects to). To create a transfer, connect some object to the conveyor. You can then delete the object you used to create the connection. The transfer will persist (since somewhere around version 20 or 21 I believe). Then tell the robot to unload to that transfer. (If you didn't use motion paths, the place offset would still be calculated such that the robot moves the item above the conveyor).

Specifying the motion path in the "Stand_By" travel activity seems to not update the next path to use correctly. Instead the robot repeats the stand by movement for the load task. Setting the fourth variable to 0 so the "Next Path Number" determines the used path works correctly.

robot-simple-simulation-ver2-fm.fsm

robot-simple-simulation-ver2-fm.fsm (820.7 KiB)

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Lamm commented · Feb 16 at 08:12 AM

thank you so much for your answer, I will study it more deeper

0 ·

question