BuildingModelOnPhase8_FromTraining83 - Scenarios_autosave.fsm
I'm simulating the labor and delivery department of the hospital that I work in. I built the model, and I want to run the different scenarios which will be "alternating the number of beds in each section". After running the experiments, the results for all the scenarios are the same! Is there anything that I did not consider? I've attached my model if that helps.
Hello @Kimia, the results are the same because the number of beds are not linked to appropriate group you can connect each group you want to right group in location group
Hi @hikel. Thank you for your response. I linked each of the parameters to their appropriate group, and changed the On Set to the proper label. However, the results for different scenarios are still the same. Is there anything else I need to check or work on?
@Kimia the problem I can see that the number you put in this table is greater than the number already in group
that is why the results are the same, here is an example number of L&R you wanna look at 24 and 27 but the number in group is just 24. even when you change it to 27 max is 24 there. double check all group member. then if the results still the same then it could be two possibility. either the changes doesn't make a difference or the process flow problem
11 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
