Can anyone please tell me the function to move the part to a specific output port from conveyor.
Part movement:
conv 1--->(output port 1) Conv 2
Conv1----->(output port 2) Sink
I am using decision point at the end and will define the movement in the "on continue" field.
Let me know if there is any other way. in the decision point I used
outobject(current,getlabel(item,"ExternalAssembly"));//externalassembly is 1 or 2.
Sachin,
Your graphic doesn't show any output ports from the DP on the conveyor. I'm not sure if they exist or not. And the proper place to put your code in the DP is in the OnArrival trigger.
Attached is a sample model that will do what you describe. Will this work for your needs?
Rather than have two different transfer points and a decision point. Just use a single Exit Transfer point, and put the logic in there. In the exit transfer you can use a "Port by Case" as the Send to Port function.
I've attached a model below as an example:
Check out the sendTo.fsm example model in this post.
You just need to connect the decision point to the exit transfers and then use the Send Item or Send Item By Case pickoptions to send the item to the desired connected object.
7 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
