As shown in below image, Can I create a Wait for Event activity where I can listen to Queue1 and Queue2 cumulative content value should be 10.
If the above is not possible, is there any other way where token should wait until the cumulative value in Queue1 and Queue2 is 10 and release once the condition is met.
I am attaching the model for reference.
I am sure someone has a better solution, but you could use 2 event triggered sources for the entry of the boxes, and then a batch. You could also use a list.
Not directly. But you can easily set up something that listens to changes on the 2 queues and then have your Wait for Event activity listen to that. Here are two examples I thought of:
Use a Zone
In this model I listen to the OnEntry of both queues with an Event-triggered source. When something enters one of the queues I have a token enter the Zone. Then I listen to that item's OnExiting event and leave the zone when that happens. This way the Zone's content is equal to the cumulative content of both queues. Then I just listen to the Zone's OnContentChange.
Use a Tracked Variable label
In this model I listen to the OnContentChange of both queues with an Event-triggered source. When either content changes I update the value of the ComboContent tracked variable label on Queue1. Then I just listen to the OnChange event of the ComboContent tracked variable.
14 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
