parameter conditioned by a label

Question

question

Cetim C asked Mar 14, '22 Roi Sánchez commented Mar 16, '22

parameter conditioned by a label

Hello,
I am trying to make a model where I have 3 possible transport alternatives and I have to decide which is the best. To do this I created a parameter from 1 to 3 that was that alternative to later be able to run the experimenter.

Well, the problem appears when I have been asked that these routing are conditioned by a type of product. 80% of the time the product is type 1 and then only alternatives 2 and 3 can be executed. The remaining 20% can be executed 1,2 and 3.
How can I encode this within the parameter itself? If there is an easier way, glad to hear it.
Thanks.

Software Version:

FlexSim 21.2.2

model parameters table

Answer 1 · 2022-03-14T12:49:54Z

Roi Sánchez answered Mar 14, '22 Roi Sánchez commented Mar 16, '22

Hello,

Take a look at the attached model. I am basically changing the lower and upper bounds of the parameter (set as an integer) depending on the value of a label (productType). I guess it should work during an experimenter run.

Support Cetim.fsm

support-cetim.fsm (145.5 KiB)

· 5

Cetim C commented · Mar 15, 2022 at 07:45 AM

Sorry, but my version is 21.2.2.
Could you attach the file in my version or lower? So I cannot open the model.

Thanks!

0 ·

Roi Sánchez Cetim C commented · Mar 15, 2022 at 08:32 AM

Here you are.

21.2 support cetim.fsm

0 ·

212-support-cetim.fsm (144.3 KiB)

Jason Lightfoot ♦ Roi Sánchez commented · Mar 15, 2022 at 08:43 AM

When I read the question I thought the task had moved away from experiment parameters to one where there is a mix of parts and routing based on the type. Attached model shows how to setup and use a Map label on the first queue to route based on type as described in the question.

Map_routes.fsm

0 ·

map-routes.fsm (27.8 KiB)

Show more comments

question