I am using Flexsim 2022 and have saved my model's results as an .fst file after running the first part of my simulation. For instance, I have data from January to December. I initially ran the simulation for January and saved the state as an .fst file.
Next time I open the model, I want to continue the simulation from the end of January, starting in February. However, when I load the .fst file and try to continue the run, it always starts over from the beginning instead of continuing from where I stopped.
I have changed all my time into seconds, so if I change the starting time, the results will be affected. I am wondering if there is any way to not change the starting time?
Is there a way to properly continue the simulation from the point where it was left off using the .fsf file? Any suggestions on how to achieve this would be greatly appreciated!
