question

Marko G avatar image
0 Likes"
Marko G asked Mario E2 answered

Why AGV moves without any work on ground floor, but lot of work in first floor

test-poto-nopo.fsm

I'm sending a model that is already running, but not quite as I would like. On the lower floor, both AGVs move (empty), even when they do not have any work, and they can already be in use on the upper floor. After a certain time when item goes (from ground floor)to the upper floor, then one or both AGVs are moving to upper floor and transfer items, but not all of them, and return to the ground floor where they circulate without work. I must also solve the problem that the movement of AGV from one floor to another will take place over the elevator (animation) and not through the connection of the two floors. If you see a possible solution, or if I have an error, I will be happy to receive any information.

AGV never transfer items from:

D12 to R12

D7 to R7

D11 to R_9_10_11

FlexSim 16.2.2
agvagv network properties
test-poto-nopo.fsm (171.7 KiB)
· 1
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Joseph Gillespie avatar image Joseph Gillespie commented ·
@Marko G

Was my answer helpful for you? Do you have any further questions?

0 Likes 0 ·

1 Answer

Joseph Gillespie avatar image
1 Like"
Joseph Gillespie answered Joseph Gillespie commented

@Marko G

The problem you were having was that there were no "Next Look for Work" connections leading to the upper floor. By adding a few of those connections I was able to solve both issues. Let us know if you have any further questions! test-poto-nopoanswer.fsm


test-poto-nopoanswer.fsm (171.0 KiB)
· 7
5 |100000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Marko G avatar image Marko G commented ·

@Joseph Gillespie

AGV moves to the upper floor with elevator, but went back from first floor via conection between two floors. Why it wont go back also vith Elevator? Is there missing any loop NextLookForWork on the first floor?

How can I optimize the movement of AGV?

medleagv-131-19-6-19.fsm

0 Likes 0 ·
medleagv-131-19-6-19.fsm (170.8 KiB)
Show more comments