Operator loading a task executer using process flow

Question

question

Bernabe Neri asked Jun 12, '19 Bernabe Neri commented Jun 14, '19

Operator loading a task executer using process flow

Hi community,

Im having trouble in solving this issue.

Im working in a sequence where an operator push a task executer to simulate operator is pushing a cart with material.

apparently all proccess flow is right but i cannot unload the task executer when is loaded by the operator.

I attached the model where im doing this part of the simulation, i only have to change the location of a task executer when operator loads it to show that operator is pushing a cart.

Thanks a lot for your support.

Regards

Bernabe Neri

Software Version:

FlexSim 18.2.3

cart

· 2

Joseph Gillespie commented · Jun 12, 2019 at 09:42 PM

Hi @Bernabe Neri

I don't see your model, could you attach it in a comment?

0 ·

Bernabe Neri commented · Jun 12, 2019 at 10:25 PM

example-line-5.fsm

sorry, i attach the model.

Regads

0 ·

example-line-5.fsm (41.4 KiB)

Answer 1 · 2019-06-13T19:49:03Z

zacharyh answered Jun 13, '19 Bernabe Neri commented Jun 14, '19

Here is a model that I created with an operator pushing a "cart" based off of your model.

operatingpushingcart.fsm

Also take a look at this link to an Answer to a similar question. It'll describe better how I was able to have an operator push a cart.

https://answers.flexsim.com/questions/22828/how-to-do-animation-for-the-operator-to-push-the-t.html

operatingpushingcart.fsm (35.6 KiB)

· 1

Bernabe Neri commented · Jun 14, 2019 at 12:58 PM

Hi Zachary, ok excelent the model runs perfectly.

Tanks for your support.

Regards

0 ·

question