assign a position to the operator at each step of a fluidmixer

Question

question

Roberto S6 asked Jan 29, '20 Braydn T converted comment to answer Feb 28, '20

assign a position to the operator at each step of a fluidmixer

tuberia.fsmIn a fluid model, I have storage tanks that supply material to the mixing tank so I use a fluidmixer. Before each supply step of the Fluidmixer, I want the operator to move to the tank he is supplying to simulate the departure port section. In the step tab you have the option to call the operator, but it only makes it move to the Fluidmixer and not to the tanks as you would like.

I hope you can support me, I would greatly appreciate it since I don't have much experience in flexsim.

regards

Software Version:

FlexSim 19.1.0

operator location fluidmixer

capture.png (311.2 KiB)

tuberia.fsm (98.8 KiB)

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Answer 1 · 2020-01-30T21:48:17Z

tannerp answered Jan 30, '20

You might be able to use my other answer to generate a token that would run a sub-flow. This sub-flow could then Acquire the operator and walk through all of the steps while the fluid mixer is stopped and then start the fluid mixer again after the operator has finished his duties. Just an idea to try, but hopefully it helps.

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

question