I have a layout which I have set the operator travel to specified location when going on break defined in TimeTable. The operator does travel to the specified location, but after leaving the simulation running for another approx. 30 sec, FlexSim crash silently.
Have I set something wrong? Could you please check my model? The simulation starts from 8:30 and at 8:31, the operator goes on break.
Your process flow is causing an infinite loop.
The down function of the time table makes the operator travel to the floor spot. When it arrives there it switches to the down state, triggering the source to create a token. This token then dispatches a travel task to the operator, causing it to switch into the "travel empty" state. As it is already at the location, the travel ends immediately and the operator enters the down state again which creates another token and so on.
At some point this loop causes FlexSim to crash.
At this point the process flow seems superflous as you already trigger the travel to the floor spot in the down function.
If you want to use the process flow, I would suggest to have the down function of the time table send a message (See the Command Helper under "Help" for the syntax of the "sendmessage" command) to the operator and listen for that with the triggered source instead of using the state change.
17 People are following this question.
FlexSim can help you understand and improve any system or process. Transform your existing data into accurate predictions.
FlexSim is a fully 3D simulation software environment. FlexSim can be used to simulate any process in any industry.
FlexSim®, FlexSim Healthcare™, Problem Solved.®, the FlexSim logo, the FlexSim X-mark, and the FlexSim Healthcare logo with stylized Caduceus mark are trademarks of FlexSim Software Products, Inc. All rights reserved.
