Processor is in the blocked state even though it is pushing items to a list

Question

question

Tyler Morrison asked Jul 2, '18 Joshua S answered Jul 3, '18

Processor is in the blocked state even though it is pushing items to a list

I am working on a simulation and when I run it some of my processors become blocked and I can't figure out why. When items are done processing they are pushed to a list and then a queue pulls them from that list. Any help is greatly appreciated.

Thanks,

Tyler Morrison

Software Version:

FlexSim 18.1.1

processor lists push to list blocked

push-to-list.png (12.4 KiB)

· 2

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Isaac Litster commented · Jul 02, 2018 at 02:19 PM

Hi @Tyler Morrison

Would you be able to upload your model for us? Thank you

0 ·

Tyler Morrison commented · Jul 02, 2018 at 02:28 PM

@Isaac Litster Unfortunately, I can't upload a model due to confidentiality reasons. I'm just not sure how a processor could be in a blocked state when it is pushing to the list because the list should always be available to receive flow items, shouldn't it?

0 ·

Answer 1 · 2018-07-02T14:38:36Z

Joshua S answered Jul 2, '18

@Tyler Morrison

Is your queue pulling from that list at all times? When an item is done at a processor, even though it is pushed to a list, the item still needs a place to be,so it will stay at the processor, blocking it, still the item is pulled and placed somewhere else.

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Tyler Morrison commented · Jul 03, 2018 at 01:02 PM

That was the issue. Some of my queues were at their max content. I didn't realize before that items needed to be somewhere while on the list. Thanks for your help.

0 ·

question