model AGV stopped by people flow

Question

question

David Chan asked Jun 04 2018 at 9:10 AM Phil BoBo edited Jun 08 2018 at 4:37 PM

model AGV stopped by people flow

Hi, I would like to model AGV being stopped by people that walked passed. I tried to do it in node network, but it did not workout. Is there anyway? Can we do this in the AGV network?

David

Software Version:

FlexSim 18.1.1

agv people flow

agv-blocked-by-people.fsm (24.0 KiB)

· 2

tannerp commented · Jun 04 2018 at 2:40 PM

@david.chan

Have you tried using a zone system? If you create a zone in which there can only be 1 object at a time, the people and the task executor should not overlap in that area.

There are several ways to create a zone in a model, including Decision Points, Photo Eyes, and Traffic Control.

Here is an example model that might give you an idea to work with. Let us know if you'd like more help with this question.

agv-blocked-by-people-with-traffic-control.fsm

0 ·

agv-blocked-by-people-with-traffic-control.fsm (24.4 KiB)

David Chan tannerp commented · Jun 05 2018 at 1:27 AM

@Tanner P Thanks for the model.

But this does not apply the situation that I need, as the situation can apply to the whole factory or hospital which I cannot possibly place Traffic control at all possible locations in the whole model. I cannot set the maximum content of the traffic control as there could be crowds moving into the same area.

For the situation I need is that the AGV should stop when people walk pass and resume when there is no people around.

Thanks for looking into it.

David

0 ·

Answer 1 · 2018-06-05T13:30:03Z

Phil BoBo answered Jun 05 2018 at 1:30 PM Phil BoBo edited Jun 08 2018 at 4:37 PM

AGV / Operator Collision Prevention

· 4

David Chan commented · Jun 06 2018 at 7:44 AM

@phil.bobo, thanks for referencing to the thread.

Can we apply the same concept to AGV that run in corridor of a hospital where people are also moving in the same place?

Thanks

David

0 ·

Phil BoBo ♦♦ David Chan commented · Jun 07 2018 at 2:41 PM

Sure.

Also, in your original example that used only network nodes, you could use a Traffic Controller to prevent the collisions.

The example in AGV / Operator Collision Prevention shows how you can stop travelers on the agv network.

0 ·

David Chan Phil BoBo ♦♦ commented · Jun 08 2018 at 9:17 AM

@phil.bobo I have attached a sample model. Will you please show me do I stop the AGV when people come close to the AGV say 1 m away. It will resume its activity when there is no people around.

Thanks

David

agv-with-hospital.fsm

0 ·

agv-with-hospital.fsm (272.6 KiB)

Show more comments

question