article

Paul Toone avatar image
0 Likes"
Paul Toone posted

Sensors Page   

Sensor Table

Displays all of the sensors for the Fluid Conveyor.

- Adds a new sensor to the table.

- Removes the selected sensor from the table, or if no sensor is selected, removes the last sensor in the table.

- Moves the selected sensor up in the list.

- Moves the selected sensor down in the list.

Start - The starting point of the sensor. This value is in the model's length units and must be greater than or equal to 0 and less than the end point.

End - The end point of the sensor. This value is in the model's length units and must be less than or equal to the total length of the conveyor and greater than the start point.

Mode - The sensor has two modes, Volume(1) and Peak Height(2). Volume will look at the total volume between the starting and ending point. Peak Height will look at the highest point between the starting and ending point.

Low, Mid, High Val - These values specify the low, mid, and high points for the volume or peak height that, when crossed, will trip the sensor. When the volume or peak height of material in a sensor range rises or falls through any of these three values, one of the three passing triggers will fire.

Sensor Triggers

Passing Low Mark - This trigger is fired when fluid volume or peak height rises or palls through the defined Low Val.

Passing Mid Mark - This trigger is fired when fluid volume or peak height rises or palls through the defined Mid Val.

Passing High Mark - This trigger is fired when fluid volume or peak height rises or palls through the defined High Val.

This Page is Used By

Fluid Conveyor



flexsim users manual
5 |100000

Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Article

Contributors

paul.t contributed to this article

Navigation

FlexSim 2016.1