Travel Sequence - Here you can specify the order in which the crane performs travel operations. Refer to the crane specifications for more information.
Speeds Table - Here you specify the max speed, acceleration and deceleration for each of the 4 operations the crane will do. Note that these operations only apply to offset travel. If the crane is connected to a network, then when it is on the network, only the normal maxspeed, acceleration and deceleration specified in the TaskExecuter page will be used.
Lift Height - Here you define how high the crane will lift to get to its lift height.
Lift Radius - Specify a radius within which the crane will not do a lift operation.
Frame X/Y/Z Location - These numbers define the location of the crane's frame. Note that this is different than the cranes actual x/y/z location. The crane's x/y/z location describes the location of the moving part of the crane. The frame will be stationary throughout the simulation, while the actual x/y/z location of the crane changes as the crane travels.
